[Table of Contents]


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [ARSCLIST] Instant Recording Discs, was Re: [ARSCLIST] Record Gunk



The record goes over the spindle as usual. My spindle solution is the same as that of everyone else.

I think I sent you the solution to a different problem- one where the record keeps slipping . Sorry.

Steve Smolian

----- Original Message ----- From: "Christie Peterson" <cpeterso@xxxxxxxxx>
To: <ARSCLIST@xxxxxxxxxxxx>
Sent: Thursday, October 12, 2006 12:32 PM
Subject: Re: [ARSCLIST] Instant Recording Discs, was Re: [ARSCLIST] Record Gunk



So, I'm having trouble visualizing this . . . is the record then balancing on the tapered part of the spindle, with the screw going through the second hole to keep it from going wonky? Is the screw supposed to literally screw into the second hole (i.e., should it be a tight fit, and providing some support to the record), or is it just loose-ish-ly keeping the record from rotating freely on the top of the spindle?

Thanks!

Christie Peterson
Project Archivist, Muskie Archives & Special Collections
Bates College
70 Campus Avenue
Lewiston, ME 04240-6018
(t) 207-753-6918
(f) 207-755-5911



Steven Smolian wrote:
The solution I use is to drill a hole in a turntable mat aligned with the second hole, stick a thin screw in it up side down, put the mat back on the turntable, and put the record on the spindle, aligning the second hole with the protruding screw.

Steve Smolian


----- Original Message ----- From: <Mwcpc6@xxxxxxx>
To: <ARSCLIST@xxxxxxxxxxxx>
Sent: Thursday, October 12, 2006 10:24 AM
Subject: Re: [ARSCLIST] Instant Recording Discs, was Re: [ARSCLIST] Record Gunk



In a message dated 10/12/2006 10:13:59 AM Eastern Daylight Time,
fbsdmd@xxxxxxxxx writes:
Other than to say drill the hole bigger, which I'm sure is the wrong
answer, I can't help with the playing of these disks. I can say, however,
that the pin in the middle of the platter has usually been called a
"spindle."
**************


Usually the tip of the spindle is tapered or rounded. A solution sometimes
suggested if the spindle is not removable, also useful for centering, is to
place other records on the turntable first to raise the disc above the start of
the taper.


Mike Csontos


--
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.1.408 / Virus Database: 268.13.2/472 - Release Date: 10/11/2006






--
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.1.408 / Virus Database: 268.13.2/472 - Release Date: 10/11/2006



[Subject index] [Index for current month] [Table of Contents]