..you might change your mind, when the NOS tubes run out and all you can
get are the terrible quality tubes from the eastern bloc countries. It
is getting painful and very expensive to find good sounding tubes even
for guitar amplifiers. I sometimes have to service tube equipment, and
the characteristics of new tubes vary all over the map. Cathode and grid
bias settings in the amplifiers don't hold at all any more because the
newly manufactured tubes are so poor. New-old-stock tubes from the US
and Europe were very stable from tube to tube. There just isn't anyplace
that wants to pollute the environment making them anymore, except where
they don't care about that. Must be why they don't care about the tube
quality either....
-----Original Message-----
From: Association for Recorded Sound Discussion List
[mailto:ARSCLIST@xxxxxxx] On Behalf Of Roger and Allison Kulp
Sent: Friday, December 21, 2007 4:29 PM
To: ARSCLIST@xxxxxxxxxxxxxxxx
Subject: Re: [ARSCLIST] FW: [ARSCLIST] Internet audio: What do you
expect of it ?
When I listen to anything other than a computer,I refuse to use anything
but tubes.
Roger
Robert J Hodge wrote: -----Original Message-----
From: Robert J Hodge
Sent: Wednesday, December 19, 2007 9:25 AM
To: 'jhartke@xxxxxxxxxxxx'
Subject: RE: [ARSCLIST] Internet audio: What do you expect of it ?
When the transistor was first marketed as an amplifying device, it
suffered from its' ability to act like a switch- that is to say until
the signal at the base became high enough to make it conduct. Germanium
and early silicon based transistors had this anomalism.
I had a couple of those early amplifiers and got rid of them after
trying to live with them. At low signal levels, they sounded terrible.
As with anything of an early design, this problem was overcome with
better transistor design.
I have used mosfet power amplifiers now for many years and will never go
back to the tube units. Of course, even overdriving a mosfet unit will
sound terrible! Clipped is clipped.
I keep the tube units around, just in case.
Bob Hodge
-----Original Message-----
From: Association for Recorded Sound Discussion List
[mailto:ARSCLIST@xxxxxxx] On Behalf Of Jerry Hartke
Sent: Wednesday, December 19, 2007 6:40 AM
To: ARSCLIST@xxxxxxxxxxxx
Subject: Re: [ARSCLIST] Internet audio: What do you expect of it ?
Being rather ancient, I go back to tube amplifiers of the 1940's, and am
confused about the reference to "solid state distortion." Does this
refer to hard clipping when transistors are overdriven? Although tube
amplifiers clip more gradually, they also introduce distortion in the
process. Thus neither form of amplification should be overdriven.
Tube amplifiers are limited by their output transformer that matches the
high output impedance of the tubes to a low load impedance. This
transformer significantly degrades frequency and phase response, placing
severe constraints on the amount of negative feedback that reduces the
inherent distortion of the amplifier. I paid as much as $100 back in the
'50s for a superior output transformer, and still struggled to achieve
20-20,000 Hz with 0.1% intermod.
Solid state amplifiers normally do not have output transformers, and
thus can use greater amounts of negative feedback. This results in much
lower distortion, better frequency (and transient) response, and
superior damping than that achieved by most tube amplifiers. It seems
that solid state amplification would be preferable provided that
amplitudes stayed within their dynamic range (always necessary for
fidelity.)
I do not disagree with those, including myself, raised on tube
amplifiers and accustomed to their limited frequency response and
somewhat higher distortion. Many of us like this "sound." However, we
should not confuse this preference with faithful reproduction.
Jerry Hartke
-----Original Message-----
From: Association for Recorded Sound Discussion List
[mailto:ARSCLIST@xxxxxxx] On Behalf Of Steven C. Barr(x)
Sent: Tuesday, December 18, 2007 11:06 PM
To: ARSCLIST@xxxxxxxxxxxxxxxx
Subject: Re: [ARSCLIST] Internet audio: What do you expect of it ?
----- Original Message -----
From: "Don Cox"
Hello Steven
On 18/12/07, Steven C. Barr(x) wrote:
----- Original Message -----
From: "Roger and Allison Kulp"
I see it as a latter day version of the all-tube FM tuner,rather
than
the CD/phono amp.
Keep in mind that the appeal of vacuum-tube audio equipment is NOT
its
"perfect" reproduction (which probably doesn't...in fact,
CAN'T...exist?!) but rather the fact that the distortion it
generates
is much more enjoyable for steady listening than its solid-state
equivalent...?!
Yes, but if you feed an unpleasantly distorted signal into a box
with a
tube in it, the tube will not magically remove that unpleasantness.
Remarkable things can be done with software to improve a nasty
recording, and I expect such software to improve in the future, but
a
simple tube based amplifier stage cannot make a silk purse out of a
sow's ear.
That, actually, was my point...! If an audio signal has been, at any
point in its life, been subjected to solid-state distortion...
1) The listener has my deepest sympathy...
2) AND...the signal will never again sound good, regardless of what it
is played on/through...!
Steven C. Barr
---------------------------------
Be a better friend, newshound, and know-it-all with Yahoo! Mobile. Try
it now.