JAIC 1984, Volume 24, Number 1, Article 3 (pp. 23 to 32)
JAIC online
Journal of the American Institute for Conservation
JAIC 1984, Volume 24, Number 1, Article 3 (pp. 23 to 32)


Antoinette Owen


GIVEN THE NUMBER OF LOSSES at the edges, the tears, and the general weakness of the paper, it was desirable to back the quadrants. A backing technique was selected that would involve a lateral drying tension of the quadrant in order to ameliorate the remaining ink/paper distortions. A sheet of .002 gauge Mylar was cut to the dimensions of the quadrant and smoothed onto a flat table surface. Strips of masking tape were laid down on the table surface 1� inches beyond each edge of the Mylar, as guidelines during the backing procedure. The quadrant was slowly wetted and brushed face down into smooth contact with the Mylar (Fig. 6). It required thorough saturation and some brushing manipulation to flatten the distortions and creases. When finally smooth, the quadrant had expanded a great deal.3 The backing procedure, therefore, was not begun until the flat quadrant had become damp rather than saturated and thus contracted almost to its original dimensions (using the Mylar to judge this). This occured within about one-half hour, facilitated by blotter applications on the verso. Since the edges of the poster tended to dry more quickly than the interior inked portion, they were frequently water-misted in order to maintain an even dampness. Six sheets of Usugami tissue were required to back one quadrant; each sheet was water cut and overlapped another by approximately � inch. Each tissue was pasted with dilute wheat starch paste and supported by Mylar, then positioned to cover approximately ⅙ of the quadrant and to extend � inch beyond the quadrant edge using the masking tape strips as guidelines. In this manner an edge of each tissue was pasted to the table surface in addition to being pasted to the verso of the quadrant (Fig. 7).

Fig. 6. The quadrant is wetted and smoothed onto mylar.

Fig. 7. The backing procedure. Note the masking tape guidelines.

As the tissues dried, a lateral stretch or drying tension was created. If the quadrant had been backed when fully expanded, the tension created probably would have caused damage either by tearing the poster or at the least separating repaired tears and pulp fills. The degree of tension of the quadrant was controlled by the degree of expansion of the quadrant at the time of backing. The Usugami tissues were fully wetted, then blotted of excess water before application. Backing with this system, although necessary because of the distortion problem, depended a great deal on judging the “moment of truth”, i.e. timing was essential. Drying of the poster was aided by application of large blotters and weights. All moisture was removed from the reverse. The blotters were changed periodically until the quadrant was completely dry. When removed from the tension system, each quadrant was flat and without distortions.4

Copyright � 1984 American Institute of Historic and Artistic Works